Advertisement
1
台面密封垫圈（Q）装在龙头（A），把手组件（J）或提拉面盖
（N）底部。安装前请检查台面是否干净平整。注意：不是所有型
号都有可选项防水垫片。
Desk Sealing Gasket (Q) posted on the bottom of faucet (A). Handle
Assembly (J) or Lift Rod Assembly Escutcheon (N). Please clean
the desk before installation. Note: Not all models have option Sealing
gaskets.
2B
将把手组件（J）及冷热水管（M），按如图所示的顺序穿过固定
螺母（I）金属垫片（G）橡胶垫片（F）安装支架（P），再将
冷热水管装入把手组件（J）。注意：把手组件带有快速接头类型
的产品，请参考此步骤进行安装。
Pass the Handle Assembly (J) and the Hot and Cold Water Supply
hose (M) through the Mounting Nut (I), Mounting Washers (G),
Gasket (F), Mounting Bracket (P) in the order shown in the figure,
and then install the Hot and Cold Water Supply Hose (M) into the
Handle Assembly (J). Note: For products with quick connector type
of handle assembly, please refer to this procedure for installation.
2A
Q
1. 将固定螺母（I）金属垫片（G），橡胶垫片（F）依次穿过冷热
2. 将软管穿过台面的安装孔。
3. 将龙头位置倾斜到合适位置，再将热水软管拧进龙头底部。
1. Put the mounting nut (I), mounting washer (G) and gasket (F)
through cold & hot supply hose (M).
2. Put the cold & hot supply hose (M) through deck installation
hole.
3. Hold faucet by hand and thread the cold and hot supply (M)
hose to the bottom of faucet.
3
P P
将水龙头的冷热水管分别正确地连接到冷热进水口.
Check that Hot and Cold Supply Hose are connected correctly to
hot and cold supplies.
3
Q
水软管（M）。
1
INS10634C - 11/18
Advertisement
