iTechworld iTECH120X Quick Start Manual
Hide thumbs Also See for iTECH120X:

Advertisement

With the bypass switch, this allows the reset mechanism to be permanently wired to your
iTECH120X and allows for remote BMS resetting, both batteries must be on the same negative
ground:
1. Install the bypass switch connecting only the positive terminals of the iTECH120X battery
and your main starting battery, or any other battery.
2. Both batteries must share the same negative ground. Once the cable is installed you can
simply press and hold the button for a few seconds to reset the BMS.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iTECH120X and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for iTechworld iTECH120X

  • Page 1 With the bypass switch, this allows the reset mechanism to be permanently wired to your iTECH120X and allows for remote BMS resetting, both batteries must be on the same negative ground: 1. Install the bypass switch connecting only the positive terminals of the iTECH120X battery and your main starting battery, or any other battery.
  • Page 2 If you have our DCDC charger, you can wire it according to the diagram below. 1. Install the bypass switch connecting only the positive cable of the iTECH120X battery and your main starting battery, or any other battery. 2. Both batteries must share the same negative ground(the iTECHBCDC25 has an internal common ground) common ground .

Table of Contents