iTechworld ITECH120X User Manual
  1. Manuals
  2. Brands
  3. iTechworld Manuals
  4. Camera Accessories
  5. ITECH120X
  6. User manual

iTechworld ITECH120X User Manual

Waterproof 120 ah lithium battery
Hide thumbs Also See for ITECH120X:

Advertisement

Table of Contents

ITECH120X
WATERPROOF 120 AH LITHIUM
BATTERY
User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ITECH120X and is the answer not in the manual?

Questions and answers

Related Manuals for iTechworld ITECH120X

Summary of Contents for iTechworld ITECH120X

  • Page 1 ITECH120X WATERPROOF 120 AH LITHIUM BATTERY User Guide...

  • Page 2: Key Features

    USER GUIDE KEY FEATURES The iTECH120X is the pinnacle of deep cycle lithium battery design. The iTECH120X charges from almost every charging system making it perfect for use in boats, caravans, motor- homes, RVS, and more. Waterproof & Dustproof IP67.

  • Page 3: Specifications

    USER GUIDE SPECIFICATIONS Nominal Voltage: 12.8v C/20 Rating usable amps 10v: 105Ah Short Circuit Protection: Yes Optimum Temperature Range: +5 to +60°C BMS Operational Temperature Range: -40 to 80°C Safety Protection Isolator: 80°C Recommended Charge Current: 20 - 50A Maximum Charge Current: 100A Recommended Charge Voltage: 14.4v BMS Charge Cut Off Voltage: 15v BMS Low Voltage Cut Off: 8.5-9v...
  • Page 4 ITECH120X SAFETY Please follow and understand these instructions before using the iTECH120X, failure to do so can cause the battery to fail. It is strictly prohibited to disassemble the iTECH120X battery. Inside the battery are electrolytes. These electrolytes can be a skin and eye irritant.

  • Page 5: Do's And Don'ts

    Exposure to sunlight can increase discharge rate of battery. If battery shows any shape change, colour change or any liquid seeping from battery stop using immediately and contact iTechworld. If the battery terminal screws are corroded, be careful not to bend the terminals when tightening or loosening.

  • Page 6: Wiring Diagram

    USER GUIDE WIRING DIAGRAM Below is an example of how a bank of iTECH120X batteries should be connected together in parallel. Please note all batteries must be of the same voltage before creating a bank. When drawing a load from the bank it should be split...
  • Page 7 The iTECH120X has sophisticated Battery Management System, Cell Balancing and the Redback Operating System pre-installed. This hardware allows the iTECH120X to be charged from almost all non lithium charging profiles. For charging systems in which the parameters can be changed we suggest following our guidelines below to optimise the system.

  • Page 8: Discharge Curve

    USER GUIDE DISCHARGE CURVE Please note that the iTECH120X's discharge curve will be different from your previous lead acid batteries. Please study the discharge curve provided below to give you a better understanding of how the iTECH120X will perform.

  • Page 9: Safe Mode

    Australia. Once such feature is "safe mode". If you draw too much power from your battery (over discharge) your iTECH120X battery will enter safe mode to protect itself. The iTECH120X will enter safe mode at a voltage of 9v or less, the terminals have been shorted or too much current has been drawn.
  • Page 10 USER GUIDE JUMPER CABLE RESET METHOD Connect the red coloured jumper lead to the (+) positive terminal of the battery which has gone into safe mode and the other end of the red jumper lead to the (+) positive terminal of another 12V battery (this can be an AGM, Gel or lead acid as it is only a temporary connection)
  • Page 11 USER GUIDE JUMPER CABLE RESET METHOD 2. Connect the black jumper lead to the (-) negative terminal of the charged battery and the other end of the black jumper lead to the (-) negative terminal of the flat battery, take care as some sparking may occur.
  • Page 12 USER GUIDE ITECH2000A JUMPSTARTER RESET METHOD The iTECH120X can also be reset using our iTECH2000A jump starter by following these steps below. You can purchase our iTECH2000A jump starter here: https://bit.ly/itech2000a Connect the jump starter clamps into the iTECH2000A jump starter, then locate the jump start button on the clamps and press and hold the button until the countdown timer is initiated.
  • Page 13 RESET METHOD 2. Within the 60 second countdown, connect the positive clamp to the positive terminal of the iTECH120X then followed by the negative clamp to the negative terminal, take care as some sparking may occur. Leave the jump starter connected until the countdown timer ends.
  • Page 14 USER GUIDE ITECHWORLD 30A BATTERY CHARGER The iTECH120X can also be reset with our 30Amp battery charger by following the steps below. You can purchase out 30Amp battery charger here: https://bit.ly/itech30abc Connect the charger positive battery clamp to the iTECH120X positive terminal and the negative battery clamp to the negative terminal, then turn on the battery charger.
  • Page 15 ITECHWORLD 30A BATTERY CHARGER 2. With the charger still powered on, remove the negative battery clamp from the iTECH120X battery momentarily then reconnect it take care as some sparking may occur. The charger will now turn on and start charging.
  • Page 16 ITECHWORLD LITHIUM BATTERY BYPASS SWITCH With the bypass switch, this allows the reset mechanism to be permanently wired to your iTECH120X and allows for remote BMS resetting, both batteries must be on the same negative ground: You can purchase the lithium battery bypass switch here: https://bit.ly/itechbypass...
  • Page 17 USER GUIDE STORING YOUR ITECH120X Long-time storage in a hot or wet environment will damage the battery. The battery should be stored in dry and ventilated environment. The ideal storage temperature is below 25℃ if stored this way, it will extend the battery life. If the storage temperature surpasses 40℃...
  • Page 18 USER GUIDE TRANSPORTING THE ITECH120X The iTECH120X battery should always be carefully handled. Don't throw the battery and avoid squeezing it i.e do not pack heavy objects on top of the battery otherwise your battery casing will warp. The battery is robust and designed to handle off-road bumps.

  • Page 19: Warranty

    “Tariff Adjustment Program” of any type.
  • Page 20 / amp-hours, regardless of the time the battery has been in service. Therefore, iTechworld reserves the right to deny a warranty claim if it determines the battery to be at its normal end of life, even if the claim is lodged within the applicable warranty period.
  • Page 21 USER GUIDE WARRANTY The iTECH120X battery is not designed or warranted in the following areas: •The Battery is NOT to be used in any Aviation aircraft application. •The Battery is NOT to be used in any lifesaving applications. •The Battery is NOT to be exported.
  • Page 22 USER GUIDE WARRANTY General Provisions: iTechworld has no obligation under the limited warranty herein in the event the battery is damaged or destroyed as a result of one or more of the following: •Wilful abuse, misuse, physical damage, neglect or if the decorative cover has been removed.
  • Page 23 •Failure to install the battery correctly will void the warranty. •Repair or attempted repair of the battery by anyone other than an authorized iTechworld representative shall void this warranty. •Normal or accelerated deterioration in the electrical qualities due to operating or application conditions.
  • Page 24 30 days of original purchase. Any defective unit that is returned to iTechworld within 30 days of the date of purchase will be replaced free of charge. If such a unit is returned more than 30 days but less than three years from the purchase date, iTechworld will repair the unit or replace it, free of charge.
  • Page 25 USER GUIDE WARRANTY Limitations This warranty does not cover damage or defects resulting from normal wear and tear (including chips, scratches, abrasions, discolouration or fading due to usage or exposure to sunlight and water), accidents, damage during shipping to our service facility, alterations, unauthorized use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, acts of god, fire, flood and force majeure.

Table of Contents

Save PDF