Advertisement
1
热水
Hot
G 1/2
管螺纹
threads on supply
G1/2
lines
供水管路布置（墙洞尺寸与距离要求）。
Configure supply lines (size and distance requirement of the wall
hole).
3
用生胶带缠上之字接头（B）较小的一头，然后接上供水管。要有
足够的生胶带以密封之字接头与出水管间的连接处。调整两弯头位
置水平, 突出墙面30mm。
Apply teflon tape to smaller ends of Z Type Connector (B) and thread
it into supply lines. Use enough teflon tape to ensure a good seal
between Z Type Connectors until they are level and at least 30mm
protruding from the wall.
冷水
Cold
墙洞最大直径为45mm
Dia.45mm max.hole in wall
B
生胶带
Teflon Tap
2
供水管
Supply lines
供水管路布置（埋管深度要求）。
Configure supply lines (depth requirement of supply lines).
4
冷
Cold
热
Hot
B
1. 将装饰罩拧紧在之字接头（B）上，并使装饰罩 ( C ) 贴紧墙面。
2. 将垫片（ D ）放入龙头主体上的连接螺母内，然后用扳手将连接螺母
与之字接头拧紧。拧紧时，最好用布包住连接螺母，避免损坏电镀面。
1. Thread Trim Cover (C) onto Z Type Connector (B), and tighten
Trim Cover (C) until they touch the wall.
2. Insert Gasket (D) into connection nuts, and then tighten the connection
nuts onto Z Type Connector (B) with a wrench. Wrap the connection nuts
with a cloth before tightening to avoid damaging the finish.
3
墙面（包括瓷砖）
Finished wall surface,
including any ceramictiles
2mm-14mm
供水管端应在墙面下
2mm-14mm
Supply lines recessed
behind finished wall
2mm-14mm
C
D
Advertisement
