Attention: This maintenance manual is only intended for the professional maintenance personnel to take reference with. Before repairing TV set please carefully read the following points of attention. Safety Instruction Before fixing and aligning this set, please read the following “Points of attention for Safety “, “Points of attention for Safety of Components”...
(29” pure flat). When the TV set needs to be fixed, please follow the inspection procedures of high voltage in item 4.11 under this instruction ”Inspection of high voltage”. It is suggested that the value of high voltage be recorded as part of maintenance work. It is most essential at the same time to use precise and dependable high voltage meter.
between the known good earthing connector (such as underground metal tube) and the exposed metal parts out of the cabinet. Measure AC voltage across both terminals. Then exchange the two pins of AC before re-measuring every exposed metal parts. The measured value of voltage should not exceed 0.3V effective value, which corresponds to current.0.2mA If the value exceeds this specified value, aligning must be made at once.
2 Flow chart of Adjustment and aligning High volt Filament volt IF Test X-ray Focus course EEPROM Picture & casse White adjustment B+volt and 5V-3V check Dark balance White balance and Color Field amplitude, SCART JACK field linearity Line field, center and field amplitude, reset Brightness Earphone...
4.1.2 There are totally three pages of factory menu. Turn the page by pushing “MENU”, Move the items by CH+/CH- key, Adjust the value by VOL+/VOL-. After adjustment, push “OK” for save. 4.1.3 The method to quit factory menu: Under the item VCT in SERVICE XOCECO-50 Hz, push EXIT: OK 4.2 IF amplifier alignment...
4.5 Sound inspection 4.5.1 Receive 1kHz sound signal 100% modulated and connect X701 with 8Ω false resistances (load). Connect sound voltage meter and Oscillograph to two poles of the false resistances. 4.5.2 Turn the sound to the biggest volume. Balance the sound and set the high/low sound to the middle, MSS OFF, DBE OFF, and the sound power should be ≥7 W×2(about 7.5 Vrms), distortion≤7% (A slight peak cutting at maximum sound sine wave is allowed.)...
The adjustment result should satisfy the scan linear geometric distortion and over scan (rate of recurrence) 4.9 Adjustment of screen-grid Focus and VG2 4.9.1 Adjust FBT Focus pole potentiometer until picture is clear. 4.9.2 Enter factory menu Cathode current (G2) item, (AV should be kept empty then), push VOL+, change to bright horizontal line and adjust the potentiometer of the line pack acceleration pole in such a way that the bight horizontal line becomes slightly bright.
WARNING: BEFORE SERVICING THIS CHASSIS, READ THE “X-RAY RADIATION PERCAUTION”, “SAFETY PRECAUTION” AND “RPODUCT SAFETY NOTICE” ON PAGE 1&2 OF THIS MANUAL. CAUTION: 1. The shaded areas makes in the schematic diagram and the parts list designate components which have special characteristics important for safety and should be replaced only with type identical to those in the original circuit or specified in the parts list.
DETAIL LIST OF ASSEBLY DRAWINGS Name Name BACK NAMEPLATE PRESS KEY SIDE AV BRACKET SET SIDEWAYS SUPPORTING BLOCK FOR CRT SCREW PUSH BUTTON PLATE BACK CABINET MAIN BOARD FRAME COMPOSITE BOLT BACK PLATE MAIN BOARD CRT FIXED SCREW PLATE ASSY’ POWER SWITCH DRAWING SPRING WITH FIBER LINE POWER PUSH BUTTON...
Need help?
Do you have a question about the TA2933 and is the answer not in the manual?
Questions and answers