Table of Contents
Advertisement
Quick Links
Operating Instruction and safety manual
3/8" Ratchet Wrench
1/2" Ratchet Wrench
ting
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being used over longer period of time or
not adequately managed and properly maintained.
4.
Wear eye protection.
1
Ratchet Wrench 17411
Model:17411
IMPORTANT:
Upon receipt of the product,
read and follow all safety rules,
operating instructions before first use it.
And retain this manual for future reference.
2013
2014
Advertisement
Table of Contents
Related Manuals for Aeropro 17411
Summary of Contents for Aeropro 17411
- Page 1 2. Damage to hearing if effective hearing protection is not worn. 3. Health defects resulting from vibration emission if the power tool is being used over longer period of time or not adequately managed and properly maintained. 2013 2014 Wear eye protection. Ratchet Wrench 17411...
- Page 2 Do not modify this assembly power tool for threaded fasteners. Modifications can reduce the effectiveness of safety measures and increase the risks to the operator. Do not discard the safety instructions; give them to the operator. Do not use the assembly power tool for threaded fasteners if it has been damaged. Ratchet Wrench 17411...
- Page 3 -and-stop device in the case of an interruption of the energy supply. unscrewing. Repetitive motions hazards or other parts of the body. whilst maintaining secure footing and avoiding awkward or off-balanced postures. The operator should change posture during extended tasks, which can help avoid discomfort and fatigue. Ratchet Wrench 17411...
- Page 4 “ringing”. safety regulations. nd maintain the assembly power tool for threaded fasteners as recommended in the instruction handbook, to prevent an unnecessary increase in noise levels. in good Ratchet Wrench 17411...
- Page 5 6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The hose diameter should be 3/8” I.D. 7. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all connections are secure. Ratchet Wrench 17411...
- Page 6 7. Make children away from the tools and workplaces. DO NOT use any additional force upon the wrench in order to remove a nut. DO NOT allow wrench to free run for an extended period of time as this will shorten its life. Ratchet Wrench 17411...
- Page 7 ■ Disconnect supply. Free motor by rotating drive shank manually where applicable ■ „O‟ rings throttle valve ■ Replace „O‟ ring . Tool will not shut off dislodged from seat inlet valve. Note: Repairs should be carried out by a qualified person. Ratchet Wrench 17411...
- Page 8 Rotor Blade Rubber handle O-ring Steel ball End plate Rear bland Idler Gear Plate Retainer ring Bearing Inlet connection Idler Gear Pin Ratchet anvil Trigger Idler Gear Pin Washer GB3452.1-92 4X1.1 Thread ring Reverse button Trigger pin gear Ratchet Wrench 17411...
Need help?
Do you have a question about the 17411 and is the answer not in the manual?
Questions and answers