Advertisement
complete but it may not be burning completed, wait for 5 minutes to shut off power. If U disk cannot be used
for burning, boot file should be burning again until U disk can be used for upgrading. ）.
2, Main board software upgrades.
1,U disk plugged into main board , put MstarUpgrade.bin software into formatted U disk , press and hold
on VOL + key button on TV key board, after about three seconds , LED starts flashing , wait until LED
lights no longer flashing and steady mean burning success. If press three seconds, LED lights (no flashing
into place) then boot files should be burned.
2, after prompting success, then click POWER on button panel to check whether main board can be
starting on, if it can be started on means burning success, otherwise as unsuccessful.
3, CI+KEY burning
i.CI + is certain TV operators encrypted to digital TV channels, need to watch the event on TV after decrypting,
if TV software upgraded , must re- burn ci + key, otherwise the
ii.client will not normally watch encrypted program .
iii.All parts on main board with CI socket must burn ci + key, if any question, please contact the engineer .
iv.ci + key running reference to "MSD6308 program ci + key count file modification ", "MSD6308 ci + key burn".
After prompting success, then
click POWER on button panel to
check whether main board can
be starting on, if it can be started
on
otherwise as unsuccessful
38
means
burning
success,
Advertisement
