INSTALLATION IMPORTANT!!! PLEASE READ BEFORE INSTALLATION ■ If the unit has recently been transported,please let unit stand still for a minimum of 24 hours before plugging it in. ■ Make sure that the unit drops down to desired temperature before loading the unit with product.
with appropriate overcurrent protection. Please refer to the electrical requirements on the nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord. SAFETY / WARNING Please pay close attention to the safety notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit.
■ Do not attempt to alter or tamper with the electrical cord. REGULAR MAINTENANCE CLEANING THE CONDENSER COIL ■ For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. ■ We recommend cleaning the condenser coil and fins at least once per month.
TROUBLE SHOOTING Before requesting any service on your unit, please check the following points. Please note that this guide serves only as a reference for solutions to common problems. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Compressor Fuse blown or circuit breaker tripped. Replace fuse or reset circuit not running.
Page 6
for long periods of time. Evaporator coil iced over. (see above) Cabinet is Loose part(s). Locate and tighten loose noisy. part(s). Tubing vibration. Ensure tubing is free from contact with other tubing or components. - 6 -...