Panasonic KX-TGF892 Operating Instructions Manual page 31

Displaying and clearing the blocked
call count
The total number of blocked calls (up to 65,000)
will be displayed.
Handset
1
MMENUN#790
R To exit, press MOFFN.
2
MCLEARN
3
MbN: "Yes" a MSELECTN a MOFFN
Adding to the allow name list
You can allow specific callers to pass through by
adding the caller's name to the allow name list.
You can store up to 100 names (16 characters
max.). If the name stored in the allow name list
matches the incoming Caller ID, the unit rings.
Callers listed in the allow name list are not
required to enter the access code.
Adding allowed names from the caller list
Handset
1
MCN CID
2
MbN: Select the desired entry. a MMENUN
3
MbN: "Save allow name" a MSELECTN a
MOFFN
Viewing/erasing an entry
Handset
1
MMENUN#794
2
MbN: Select the desired entry.
R After viewing, press MOFFN to exit.
3
MERASEN a MbN: "Yes" a MSELECTN a
MOFFN
Erasing all entries
Handset
1
MMENUN#794
2
MERASEN a MbN: "Yes" a MSELECTN
3
MbN: "Yes" a MSELECTN a MOFFN
For assistance, please visit http://shop.panasonic.com/support
KX-TGF892_(en-us)_0426_ver201.pdf 31
Enhanced Call Block
Greeting message for automated call
block
Handset
When the unit answers a call, a greeting message
is played to the caller.
You can use either:
– your own greeting message and pre-recorded
greeting message
– pre-recorded greeting message
Recording a greeting message for automated
call block
Using this feature, the unit can play your own
greeting message and pre-recorded greeting
message.
Example of your own greeting message:
"Hi, you have reached xxxxxx (Name)."
"Thank you for your calling, You have reached
xxxxxx (Name)."
"Hi, you have reached the xxxxxx (Name)
residence."
1
MMENUN#791
2
MbN: "Yes" a MSELECTN
3
After a beep sounds, hold the handset about
20 cm (8 inches) away and speak clearly into
the microphone (2 minutes max.).
4
Press MSTOPN to stop recording.
5
The unit will play the recorded greeting
message for automated call block. a MOFFN
Resetting to the pre-recorded greeting
message for automated call block
This procedure will erase your greeting message
for automated call block and reset to the
pre-recorded one.
1
MMENUN#793
2
MYESN a MOFFN
Playing back the greeting message for
automated call block
1
MMENUN#792
2
To exit, press MOFFN.
31
4/26/2022 3:14:18 PM