Table of Contents
Advertisement
Only use sockets which are specifically designed for use with the wrench.
Changing sockets
Disconnect the tool from the source o f compressed air.
Remove the socket you no longer wish to use from the anvil.
Subsequently fit the new socket to the square drive as described above.
DO NOT use any additional force upon the wrench in order to remove a nut.
DO NOT allow wrench to free run for an extended period of time as this will
shorten its life.
6. MAINTENANCE
WARNING: Disconnect wrench from air supply before changing accessories,
servicing or performing maintenance. Replace or repair damaged parts. Use
genuine parts only. Non-authorised parts may be dangerous.
Lubricate the air wrench daily with a few drops of air tool oil dripped into the air inlet
1.
DO NOT use worn or damaged sockets.
2.
Loss of power or erratic action may be due to the following:
3.
−
Excessive drain on the air line.
−
Moisture or restriction in the air pipe.
−
Incorrect size or type of hose connectors.
To remedy check the air supply and follow instructions.
Grit or gum deposits in the ratchet wrench may also reduce performance. If your
4.
model has an air strainer (located in the area of the air inlet), remove the strainer
and clean it.
When not in use, disconnect from air supply, clean air ratchet wrench and store in a
5.
safe, dry, childproof location.
7. TECHNICAL DATA
Model
No load speed
Max. torque
Air pressure
Air inlet size
Avg. air consumption
Net weight(without
accessories)
8. TROUBLESHOOTING
CT0675
3/8"D i
150 /min
45 ft-lb
6.3 bar
1/4"
4cfm
1.2kg
7
Advertisement
Table of Contents
