Table of Contents
Advertisement
Select Rinse/Spin (deactivate the
2.
Rinse Plus/Aqua Plus button) or
select Empty.
Select Start/Reload.
3.
Programme end during rinse
hold
- - - appears on the display panel, the O
status display lights up and the "Start/
Reload" button indicator lamp flashes.
To end the programme, set the
programme selector to "Empty" or
select a spin speed. Then press the
Start/Reload button.
Programme end
-0- appears in the display panel and the
"Start/Reload" button indicator light
flashes.
If the x symbol also appears in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Turn the programme selector to Off.
2.
Appliance is switched off.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door
■
and detergent drawer open so that
any residual water can dry away.
H
Sensors
A utomatic load sensing
S e n s o r s
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry in the drum (from ~ Page 24).
Sensors
en
19
Advertisement
Table of Contents
