Child Lock; Adding Laundry; Changing The Programme; Cancel The Programme - Siemens WM14W520IL Instruction Manual And Installation Instructions

Child lock

(w 3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To activate/deactivate, press and hold
the Finish in 5 - and + buttons at the
same time for approx. three seconds.
The w symbol is appears in the
display panel.
w lights up: The childproof lock is
■
active.
w flashes briefly: The childproof
■
lock is active and the programme
selector was turned or a button was
pressed.
The childproof lock remains
Note:
active, even once the washing machine
has been switched off. Before selecting
the next programme, deactivate the
childproof lock.

Adding laundry

After starting the programme, you can
add or remove laundry if necessary.
Press the Ü button to do this.
The Ü button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
Both the - P - and Ï symbols light
■
up, it is possible to add laundry.
- P - lights up, it is not possible to
■
add laundry.
To continue the programme, press the
Ü button. The programme continues
automatically.
Operating the appliance
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
The load display is not active during
■
reloading.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press the Ü button.
1.
Select another programme.
2.
Press the Ü button. The new
3.
programme starts from the
beginning.

Cancel the programme

For programmes at high temperatures:
Press the Ü button.
1.
To cool down laundry: Select Rinse .
2.
Press the Ü button.
3.
For programmes at low temperatures:
Press the Ü button.
1.
Select Spin or Empty .
2.
Press the Ü button.
3.
Programme end during rinse
hold
In the display panel, $ flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
Pressing the Ü button or
■
Changing the spin speed, or setting
■
the programme selector to Empty
and then pressing the Ü button.
en
25