Table of Contents
Advertisement
2. ANODE CAP REINSTALLTION
Observe the cautions carefully so that no accident
occurs due to a defect in installing the anode cap and
so it does not come off.
2-1. Caution before Reinstalling
Never turn the anode cap after installing it
Never re-use the hook when it has been deformed
(1)
If the anode cap is turned after it is installed, it may
come off. Therefore, arrange the high-voltage cable
before attaching the anode cap. (See Figure 1-1)
(2)
If you have attached the anode cap before arranging
the high-voltage cable, arrange the cable carefully so
the cap does not turn.
2-2. Anode cap reinstallation
(1)
Use a clean cloth moistened slightly with alcohol to
clean the installation section. (See Figure 2)
Caution : Check that the installation section is free
from dust, foreign matter, etc.
(2)
Coat the anode cap installation circumference with an
appropriate amount of the specified silicone grease
(KS-650N). (See Figure 2)
Caution : Be careful that silicone grease does not
enter the anode button.
(3)
Eliminate twisting, etc. of the high-voltage cable and
arrange it so that no twisting occurs. (See Figure 3)
Caution : If the cable is not arranged correctly, the
anode cap could turn and cause an
installation defect.
Left
5
Anode cap
Right
Anode button
Installation
section
High-voltage cable
Anode cap
Fig. 1-1
Fig. 2
Fig. 3
Advertisement
Table of Contents
