Technical Specifications For Avr-S510Bt - Denon AVR-S510BT Service Manual

TECHNICAL SPECIFICATIONS FOR AVR-S510BT

n Audio Section
• Power amplifier
Rated output :
Front :
70 W + 70 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
90 W + 90 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center :
70 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
90 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround :
70 W + 70 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
90 W + 90 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Output connectors : 6 – 16 Ω/ohms
• Analog
Input sensitivity/Input impedance : 200 mV/47 kΩ
Frequency response: 10 Hz – 100 kHz — +1, –3 dB (Direct mode)
S/N : 98 dB (IHF–A weighted, Direct mode)
n Tuner section
FM (Note: μV at 75 Ω, 0 dBf = 1 x 10
Reception frequency range :
Effective sensitivity :
50 dB sensitivity :
S/N ratio :
Distortion :
W)
–15
FM 87.5 MHz – 107.9 MHz
AM 520 kHz – 1710 kHz
FM 1.2 μV (12.8 dBf)
AM 18 μV
FM MONO 2.8 μV (20.2 dBf)
FM MONO 70 dB
(IHF–A weighted, Direct mode)
STEREO 67 dB
(IHF–A weighted, Direct mode)
FM MONO 0.7 % (1 kHz)
STEREO 1.0 % (1 kHz)
n Bluetooth Section
Communications system :
Transmission power :
Maximum communication range : Approx. 32.8 ft/10m in line of sight
Frequency band :
Modulation scheme :
Spectrum)
Supported profiles :
Corresponding codec :
Transmission range (A2DP) :
n General
Power supply :
Power consumption : 310W
Power consumption in standby mode: 0.1 W
Power consumption when Bluetooth standby is used: 1W
For purposes of improvement, specifications and design are subject to
change without notice.
9
Bluetooth Version 2.1 + EDR
(Enhanced Data Rate)
Maximum 2.5 mW (Class 2)
2.4 GHz band
FHSS (Frequency-Hopping Spread
A2DP
(Advanced Audio Distribution
Profile)1.2
AVRCP
(Audio Video Remote Control
Profile)1.5
SBC, AAC
20 Hz - 20,000 Hz
AC 120 V, 60 Hz