Advertisement
WARMING DRAWER
Installation Specifications (Non-Integrated)
The warming drawer is designed to be set into a built-in installation alone, or in combination with a Wolf wall oven,
microwave oven or cooktop. The illustration below shows the rough-in dimensions for a "non-Integrated" warming
drawer installation below a wall oven
NOTE:
Prior to serial #13005870, the warming drawer could not be installed in an Integrated application. See
rough-in dimensions for an Integrated application on following page.
For complete installation instructions, refer to the installation guide.
NOTE:
1.5" X 1.5"
(3.8 mm X 3.8 mm)
Anti-Tip Block
must be installed.
* Dimension may vary by ± 1/8" ( ± 3 mm)
= Electrical outlet location
E
NOTE:
Figure 2-2. Non-Integrated Warming Drawer Installation below a Wall Oven
#802981 Rev. A Jan. 2005
(See Figure 2-2).
5"
(127)
E
*28-1/2"
(724)
*9-1/4"
(235)
Dimensions in parentheses are in millimeters.
Installation Information
4"
(102)
NOTE:
If installed below Wolf
23-1/2" min
wall oven, rail between
(597)
appliances must be
minimum 1-1/4" (318 mm) thick.
23"
(584)
2-3
FRAME
10-1/4"
(260)
FRAME
29-7/8"
(759)
Advertisement
