APEX FORGE M6 User Manual page 19

5
rotary tool.
6 Insert the hex key into the hole
on the handle.
8
fastened.
Operating Instructions
For optimum performance, allow your new flexible driver attachment to run
at high speed on your rotary tool in a vertical position for 2 minutes before
use (Fig.). Disengagement of the flexible driver The flexible shaft may
become disengaged if the motor of your rotary tool is not elevated Higher
than the working end of the Flexible Driver.
Flexible Shaft Lubrication
The flexible driver should be lubricated after every 25-30 hours of use. To
lubricate, Unscrew the flexible driver assembly from the motor housing. Pull
the center core out of the flexible driver assembly. Wipe a very thin film
automotive wheel bearing grease on to the center core and reinsert
7 Loosen collet nut then insert
shank of accessory into collet.
b
- 17 -
a
Fig