Cutting Guide - APEX FORGE M6 User Manual

Removing the Detailer's Grip Attachment
1.
Hold the handle B firmly and twist the tool until the nose piece D is loose. Remove
nose piece D and handle B from housing collar C and reinstall original nose cap A
(Fig. 2).
FIG.1
A

Cutting guide

The cutting guide comes completely assembled and ready to use on a variety of
materials up to 20mm thick. Always hold the tool firmly, using a slow steady pressure
to guide the tool through your work. The speed of the tool will do the work.
IMPORTANT: Always cut in clockwise direction except when following a template
(outlet box), then cut in counter clockwise direction.
Installation Instruction of the Cutting Guide Attachment
Step 1 & 2) Remove the collet nut and then the housing cap from the end of your
rotary tool.
Step 3) Place the collet nut loosely on the end of the rotary tool and insert the cutting
bit. Tighten collet nut.
Step 4) Thread the Cutting Guide Attachment onto the exposed housing threads on
the rotary tool.
Step 5) Adjust the attachment to the desired cutting depth.
FIG.2
D
- 13 -
C
B