Installation Instructions - APEX FORGE M6 User Manual

Driver to disengage from the tool. The minimum recommended bend radius is 6"（
15CM）.
Always hold the hand piece firmly in your hands during the start-up. The reaction
torque of the motor, as it accelerates to full speed, can cause the shaft to twist.
Not for use with router bits or other large diameters (1" or larger) bits. Large diame-
ter bits can cause kickback and loss of control when used with the Flexible Driver.
Do not remove end ferrule while tool is running. The cable will become loose from
the jacket and will uncontrollably whip or lash around.

Installation Instructions

It is extremely important to carefully read and follow the directions below to
assemble the Flexible Driver to your rotary to ensure the tool will function properly.
1 Remove the shaft collar.
3 Raise the handle end of
gently until the inner
4
nut. The metal ring on the inner core must be flush against the collet
before tightening.Otherwise the extra length of the inner core will
generate excessive friction and heat.
2 Loosen the collet nut.
a
Metal Ring
- 16 -
b
Collet