Advertisement
shaft. Make sure that you insert the webbing from top to bottom and that the line comes straight out
of the ratchet. Tighten the line by holding onto the band with one hand and ratcheting with the other.
1.5 complete windings, maximum 2.5 complete windings. The tension on the lever of the ratchet must
not exceed 400 N (40 kg).
Releasing the Slackline:
2.Removing the line out ratchet slot gently and
wrap up the line for next use.
SLACKLINE CAN BE USED WITH OBSTACLE ACCESSORIES AS MONKEY LINE.
OPTIONAL OBSTACLE ACCESSORIES (sold separately)
4.Close the ratchet, making sure that the bolt rests in
the cogging and move the lever to a horizontal
position. The ratchet should be underneath the line so
as not to interfere with slackline.
To release ratchet, pull the pawl (small lever inside the
1.
ratchet). Open the lever by pulling on it. Make sure the lever
is completely open and flat. Now, you can pull the band out.
This step should be done slowly to avoid damage to the
webbing.Releasing too fast may cause injury.
:
1. Jointer (Buckle set and Delta clip) + Slackline
Handle
2. Jointer (Buckle set and Delta clip) + Slackline
Rope
3. Jointer (Buckle set and Delta clip) + Swing
handles
4. Jointer (Buckle set and Delta clip) + Swing Rope
3
Advertisement
