Advertisement
● Keep people at least 10 ft. away from the Slackline course when it is in use.
● Never use the line when it is wet or if there is rain or lightning in the area or predicted.
● Do not use the line if any parts are worn or damaged.
● Not suitable for children under 5 years old.
● Keep assembly and installation instruction for further reference
FAILURE TO FOLLOW THESE RULES COULD RESULT IN SERIOUS INJURY OR EVEN
DEATH!!
INSTURCTIONS FOR INSTALLING THE SLACKLINE.
Contents
The slackline training set consists of a 50mm wide webbing with covered strap. The ratchet is fixed
on a shorter, 50mm wide webbing. Accessories include: 2 pieces tree protectors, 1 piece ratchet
protectors and one drawstring bag.
Caution: Do not use any components other than the ones provided in this Slackline training set. Be
sure to follow all safety guidelines!
Assembly:
to prevent damage to the trees.
1.Choose a tree with minimum circumference of 1
m (30 cm diameter) and maximum circumference
of 1.8m. Please be sure that the trees can
withstand force of at least 25 kN (2.5t). It is
suggested to use tree protectors to cushion the line
2.Wrap the band without the ratchet flat around your fixed point.
Be aware not to anchor it higher than the maximum height of 50
cm off the ground. Feed the band through the strap and tighten to
the tree.
TIP: Place the line in the center of the fixed point. Fold the band
when threading it through the strap to make the line straight.
3.Take the ratcheted band and wrap it around a tree at
the same height. Thread the ratchet through the covered
strap so that a loop is formed. Install the ratchet with the
lever facing down, it will be more simple and secure.
Pull on the small lever inside the ratchet in order to
release it and open the main lever. Insert the loose end of
the webbing avoiding any twists in slot of the winding
2
Advertisement
