Advertisement
Begin by making sure the Game Inserts that came with your scoreboard are in the proper
A Note about the LCD Display:
The LCD display provides the scorer with any information that the scoreboard will
display. Some features are not automatically displayed and must be enabled. Take a look
at your scoreboard and determine which features you want to use and which you do not.
Example: Your scoreboard has an AT BAT feature, which can be disabled without
changing the ability of the scoreboard to function. If it is disabled, the information will not
show on the LCD display, and you will not go through the steps required to use the
feature. However; if it is enabled, a few simple keystrokes are all that is required to use the
feature.
The Up/ Down Arrows on the GAME Keypad are used to scroll the information on
the LCD Display. There are two lines of text. Pressing either arrow will cycle those lines of
text.
When the POWER switch is turned ON the controller's LCD will show the following:
To Continue Last Game Press ENTER, To Start New Game Press RESET
Pressing ENTER will recall information from the last game that was played and display
it on the controller and scoreboard. At this time game play can resume.
Pressing RESET will begin a new game. The scoreboard and controller will display the
default start up information with zeros in BALL, STRIKE, OUT, HOME/GUEST 1
INNING scores, TOTAL RUNS, TOTAL HITS, H/E, E.
GETTING STARTED
location on the controller, as in the image below.
st
Advertisement
