Communication Cables - MACGREGOR MSBBS3 LED Operating Instructions Manual

COMMUNICATION CABLES

Connecting a Hard Wired Cable
Using the supplied 20-ft. DIN cable, connect one end to either of the DIN sockets
on back of the controller and the other end to the junction box receptacle.
Connect the AC Adapter to the power jack on the back of the controller and into a
standard 120V power source. If you are not using a wall receptacle, make sure the
connection is stable. A power strip serves as a better power source than an
extension cord. Extension cords do not always provide a stable power source.
Cable Connection Wireless Connection
Connecting a Wireless Transmitter
Connect the transmitter to the controller by plugging one end of the transmitter's
attached interface cable into the transmitter and the other end to either of the
controller's DIN sockets on back of the controller. Place the transmitter into the
supplied clip on back of the controller.
Connect the AC Adapter to the power jack on the back of the controller and into a
standard 120V power source. If you are not using a wall receptacle, make sure the
connection it stable. An outlet bar serves as a better power source than an
extension cord. Extension cords do not always provide a stable power source.