Table of Contents
Advertisement
CN24 (Front Audio Connector)
This connector give you the option of a front panel audio jack
cable ext. to be plug into a special custom designed system case.
Simply remove the two jumper caps at pin [5-6] and [9-10] then
plug it into the (optional) cable ext. connector. Pin [5-6] and
[9-10] are shorted (default) to enable the back panel audio
function.
IR2 (IR Connector)
Select a UART Mode in BIOS's Integrated Peripherals menu the
UART port to support IR function. (See section 3.4 Super I/O
Device of Integrated Peripherals)
Chapter 2
Chapter 3
Phoenix-Award BIOS ROM has a built-in setup program that allows users to modify
the basic system configuration. This information is stored in CMOS RAM so that it
can retain the setup information, even when the power is turned off.
To enter the Phoenix-Award BIOS setup program press the [Delete key] when you
Power on or reboot the computer system. The primary screen as shown in Figure 3-1
is a list of the menus and functions available in the setup program. Select the desired
item by your arrow keys and press enter to make the changes. Operating commands are
located at the bottom of this and all other BIOS screens. When a field is highlighted,
on-line help information is displayed on the right side of the screen.
3-1 Standard CMOS Setup
The Standard CMOS Setup allows users to configure system components such as hard
disk drive, floppy disk drive and video display as well as date, time and boot-up error
signaling. This configuration menu should be changed when installing a motherboard
for the first time, changing hardware in your system such as the HDD, FDD, video
display, or when the CMOS data has been lost or contaminated. Choose the Standard
CMOS Setup option from the CMOS Setup Utility menu (Figure 3-1) to display the
following screen.
Set the date and time of the system. Do not skip this function as all of your timed
events such as power management, saving files, etc are based on this timer.
This category identifies up to four IDE hard disk drives that have been installed in the
computer. This section does not show information on other IDE devices such as
CD-ROM drives or other hard drive type such as SCSI drives.
Select different Floppy device Model. Available options are [None], [360K, 5-1/4 in],
[1.2M, 5-1/4 in], [720k, 3-1/2 in], [1.44M, 3-1/2 in], and [2.88M, 3-1/2 in].
7
8
BIOS Setup Program
Chapter 3
Figure 3-1 Setup Program Initial Screen
Date/Time
IDE (Primary/Secondary; Master/Slave)
Drive A/B
Advertisement
Table of Contents
