Appendices How To Use The Project File; Operation Flow - Omron V330-F Series Connection Manual

9. Appendices How to Use the Project File

This section explains the procedure for using the following project file. The project file contains
the settings described in 7.3. Controller Setup.
Obtain the latest version of the project file from OMRON Corporation.
Name
Sysmac Studio Compact
Project File (Extension:
csm2)
Sysmac Studio Compact
Project File (Extension:
csm2)

9.1. Operation Flow

The procedures for setting up the EtherNet/IP tag data links using the project file are as
follows.
Refer to the respective sections, except for 9.2.1. Loading the Project File shown in the red
frame.
7.2. Code Reader Setup

9.2. Controller Setup
▼
7.3.1. Setting the IP Address
▼
9.2.1. Loading the Project File
▼
7.3.7. Transferring the Project
Data

7.4. Checking the EtherNet/IP
Communications
9. Appendices How to Use the Project File
Filename
OMRON_V330_NX_EIP_V100.csm
2
OMRON_V430_NX_EIP_V101.csm
2
Set up the code reader.
Set up the controller using the project file.
Start the Sysmac Studio and set the IP address of the
controller.
Load the project file in the Sysmac Studio.
Place the Sysmac Studio online and transfer the
connection settings and project data to the controller.
Check that the EtherNet/IP tag data links are
operating normally.
Version
Ver. 1.00
Ver. 1.01
49