Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Tchibo 398 498
Summary of Contents for Tchibo 398 498
- Page 1 The Tchibo Bean to Brew Machine Keep for future use! Operating instructions and warranty Tchibo GmbH D-22290 Hamburg · 109547HB_GFT · 2022-08 109547 en Kaffeevollautomat_USA_v4.indd 1 109547 en Kaffeevollautomat_USA_v4.indd 1 31.08.22 09:45 31.08.22 09:45...
-
Page 2: Table Of Contents
Contents About these instructions 17 Adjusting the amount of the beverage Intended use 18 Adjusting the grinding degree Location 19 Expansion for the coffee bean IMPORTANT SAFETY compartment INSTRUCTIONS 20 Adjusting the automatic rinsing At a glance (delivery contents) cycle 10 Removing protective films and 21 Standby mode packaging materials... -
Page 3: Location
About these instructions Intended use This product is equipped with safety features. Nevertheless, read the safety warn- The coffee machine has been devised for the following uses: ings carefully and only use the product as described in these instructions to avoid •Preparing espresso and other coffee beverages from whole accidental injury or damage. - Page 4 IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS 9. Do not let cord hang over edge of table or counter, or touch hot surfaces. 1. Read all instructions. 10. Do not place on or near a hot gas or electric burner, 2. Do not touch hot surfaces. Use handles or knobs. or in a heated oven.
- Page 5 •Always pull on the mains plug, not the cord. to serious injuries. In the case that magnets are swallowed or inhaled, seek medical advice immediately. •To disconnect the machine fully from the mains, unplug Risk of injury to people restricted in their capability of the mains plug from the wall socket.
- Page 6 •Change the water in the water tank daily to prevent germs •Always pour fresh, cold tap or other drinking water into the from collecting. water tank. Do not use carbonated mineral water or any other liquids. •Use only the cleaning and descaling agents listed in this manual as well as the relevant cleaning utensils to clean •...
- Page 7 •Route the connecting cord in such a way that it cannot be tripped over. Do not let the connecting cord hang down from the surface the machine is put on, so that the machine cannot be pulled down by it. •Keep all cards with magnetic strips, such as credit cards, debit cards, etc.
- Page 8 At a glance (delivery contents) Opening for the Grind adjuster water tank Cover for the Coffee bean compartment 5.6 oz. (160 g) coffee bean Water tank compartment Control panel Height-adjustable coffee spout Coffee spout opening Coffee grounds container Filter (for filtering out limescale or other parti- cles)
- Page 9 Control buttons (white) Expansion for the coffee bean compartment The control buttons are only visible when the machine is switched on. Make an Make a Make a espresso regular large coffee coffee Connecting cord Boost Rinsing/ button heat cup Warning lights (orange) The warning lights only light up when the machine requires maintenance.
- Page 10 Packaging material 3. Pull the water tank up and out. In the water tank you will find The packaging material protects the unit during shipping. the expansion piece for the coffee bean compartment and The original packaging can be kept for future transport of the unit. the cleaning brush.
- Page 11 Initial operation – prior to first use 2. Push the drip bowl and drip grid all the way into the machine as illustrated. Place the machine ... The drip bowl is held in place by ... on a level worktop or surface that is not sensitive to moisture. magnets.
- Page 12 5. Reinsert the water tank in the 8. Place the lid back on the coffee machine and push it down as far bean compartment. as it will go. Press the lid all the way on so that the aroma protection seal can optimally protect the aroma of the coffee beans.
- Page 13 Adjusting the height of the coffee spout 12. Pour out the water in the drip bowl if necessary. 13. Rinse out the machine twice as You can adjust the height of the coffee spout to match the size of the cup. described in the "Rinsing the machine"...
- Page 14 Rinsing the machine 6. Pour out the water in the drip bowl if necessary. After switching the machine on for the first time or if you have not used the ma- chine for longer than two days, rinse the machine by allowing two cups of water to flow through it.
-
Page 15: Make A Coffee
Make a coffee CAUTION - Risk of burns from hot liquids Prerequisite: Hot water or coffee from the coffee spout may cause burns. • The machine is switched on and ready for operation. • Do not touch the coffee spout during and shortly after use of the machine. 1. - Page 16 Empty coffee grounds container, leftover water tray 2. Empty the coffee grounds con- and drip bowl tainer, the leftover water tray and the drip bowl. When the coffee grounds container is full (after 10 brewings), the "Empty coffee grounds" symbol 3.
-
Page 17: Adjusting The Amount Of The Beverage
Preheating the cup Adjusting the amount of the beverage Fill the cup with hot water and then pour it away shortly before using the cup. You can change the preset settings for the water quantity permanently. You can This helps espresso, regular coffee and large coffee taste their best. customize the setting for each type of coffee: One each for espresso, regular cof- fee and large coffee. -
Page 18: Adjusting The Grinding Degree
Restoring the factory settings 2. Remove the lid from the coffee bean compartment. You can restore the original settings for the amount of beverage. The grind regulator is located in 1. Press and hold both the on/off the coffee bean compartment. switch and the boost button It is preset to level 2 upon deliv- (for approx. -
Page 19: Expansion For The Coffee Bean Compartment
Expansion for the coffee bean compartment Increasing the fineness of the grind Increase the fineness of the grind when you want the coffee to flow more slowly You can increase the capacity of the coffee bean compartment from 5.6 oz. (160 g) and have more aroma, for example if the coffee is too weak for your taste. - Page 20 Adjusting the automatic rinsing cycle 4. Fill coffee beans into the coffee bean compartment. At the factory, the machine is preset that the automatic rinsing cycle only starts when the machine is cold. If the machine was already in operation shortly before being switched on and is therefore still warm, the machine will not rinse again.
-
Page 21: Standby Mode
Standby mode Cleaning Always switch the machine into standby mode using the on/off switch after use. The machine will then use very little energy. If no button is pressed for about ten DANGER – Risk of fatal electric shock minutes, the machine will automatically switch to standby mode. This is both a An electric shock will result in serious injury or death. - Page 22 Cleaning the casing 1. Remove the drip bowl. Wipe the casing with a soft, damp cloth. 2. Pull the leftover water tray with the coffee grounds container out Also wipe the compartment for the leftover water tray with a soft, damp cloth of the machine.
-
Page 23: Cleaning The Brewing Unit
6. Place the drip grid in the drip 3. Remove the cover from the bowl and connect the parts to machine. the machine. 4. Firmly press and hold the two orange-colored buttons and pull the brewing unit straight forward out of the machine. Cleaning the brewing unit CAUTION - Danger of burns from a hot brewing unit The brewing unit becomes hot when preparing a drink. - Page 24 8. Press the brewing unit back into the machine using some force, and without pressing the Click ! orange-colored buttons. You should hear and feel the brewing unit lock into place. The brewing unit must be firmly seated in the holder. 9.
-
Page 25: Descaling
Descaling 1. Pull the water tank up and out of the machine. NOTICE - Material damage due to limescale Formation of limescale could damage the machine. •Descale the machine as soon as the machine indicates that this is necessary. This increases its service life and saves energy. 2. - Page 26 5. Press and hold both the on/off 9. Take the water tank out of the switch and the espresso button machine. (for approx. 5 seconds) until 2 beeps sound. 6. Release the buttons. The "Descale" symbol is lit 10. Thoroughly clean the water tank up and ...
-
Page 27: For A Long Period Of Non-Use
About half of the water in the tank is rinsed through the machine. The "Empty system" The machine will then pause for about 1 minute. Then the second half of the symbol flashes. water in the tank is rinsed through the machine. Afterwards, the machine will automatically switch into standby mode. -
Page 28: Problems / Solutions
Is the brewing unit or the brewing unit cover not correctly in place? Additional information and helpful video instructions are available on the Internet Remove the brewing unit cover and make sure the brewing unit is firm- at: https://www.tchibo.com ly in place (see "Cleaning" chapter / section "Cleaning the brewing unit"). -
Page 29: Technical Specifications
In the course of product improvement, we reserve the right to make technical and optical modifications to the product. FULLY AUTOMATIC COFFEE MACHINE E514673 Product number: 398 498 109547 en Kaffeevollautomat_USA_v4.indd 29 109547 en Kaffeevollautomat_USA_v4.indd 29 31.08.22 09:51 31.08.22 09:51... - Page 30 109547 en Kaffeevollautomat_USA_v4.indd 30 109547 en Kaffeevollautomat_USA_v4.indd 30 31.08.22 09:51 31.08.22 09:51...
- Page 31 109547 en Kaffeevollautomat_USA_v4.indd 31 109547 en Kaffeevollautomat_USA_v4.indd 31 31.08.22 09:51 31.08.22 09:51...
- Page 32 109547 en Kaffeevollautomat_USA_v4.indd 32 109547 en Kaffeevollautomat_USA_v4.indd 32 31.08.22 09:51 31.08.22 09:51...