CHAPTER 6. CIRCUIT SCHEMATICS AND PARTS LAYOUT
[1] Notes On Schematic Diagram
Resistor:
•
To differentiate the units of resistors, such symbol as
K and M are used: the symbol K means 1000 ohm
and the symbol M means 1000 kohm and the
resistor without any symbol is ohm-type resistor.
Besides, the one with "Fusible" is a fuse type.
•
Capacitor:
To indicate the unit of capacitor, a symbol P is used:
this symbol P means pico-farad and the unit of the
capacitor without such a symbol is microfarad. As to
electrolytic capacitor, the expression "capacitance/
withstand voltage" is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
[2] Types Of Transistor And LED
TOP VIEW
(1) (2) (3)
1117Y33
1N4004
TOP VIEW
•
Schematic diagram and Wiring Side of P.W.Board
for
this
model
improvement without prior notice.
•
The indicated voltage in each section is the one
measured by Digital Multimeter between such a
section and the chassis with no signal given.
•
Parts marked with "
maintaining the safety of the set. Be sure to replace
these parts with specified ones for maintaining the
safety and performance of the set.
T
O
P
V
E I
W
(1) (2) (3) (4) (5)
NM3421
TOP VIEW
DXA010
6 – 1
are
subject
to
change
" are important for
C
(2)
T
O
P
V
E I
W
B
E
(3)
(1)
KRC104S
HT-SL50
for