Control Panel - AEG A51100TSW0 User Manual

cient ventilation follow the instructions
relevant to installation.
• Wherever possible the back of the
product should be against a wall to
avoid touching or catching warm parts
(compressor, condenser) to prevent
possible burn.
• The appliance must not be located
close to radiators or cookers.
• Make sure that the mains plug is ac-
cessible after the installation of the ap-
pliance.
• Connect to potable water supply only
(If a water connection is foreseen).
1.6 Service
• Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
• This product must be serviced by an
authorized Service Centre, and only
genuine spare parts must be used.

2. CONTROL PANEL

Green Indicator Light
1
Red Indicator Light
2
Yellow Indicator Light
3
Freezer Switch
4
Temperature Regulator
5
2.1 Switching on
1. Allow the appliance to stand for 4
hrs after installation.
2. Insert the plug into the wall socket.
1 2
1.7 Environment Protection
This appliance does not contain
gasses which could damage the
ozone layer, in either its refriger-
ant circuit or insulation materials.
The appliance shall not be dis-
carded together with the urban
refuse and rubbish. The insula-
tion foam contains flammable
gases: the appliance shall be dis-
posed according to the applica-
ble regulations to obtain from
your local authorities. Avoid
damaging the cooling unit, espe-
cially at the rear near the heat ex-
changer. The materials used on
this appliance marked by the
symbol
3 4
3. Turn the Temperature Regulator
clockwise to a medium setting.
4. The Green Indicator Light will light
up and remain lit until the appliance
is switched off at the mains.
5. Press the Freezer Switch to activate
the fast-freeze function (Yellow Indi-
cator Light will illuminate) and leave
to run for 4 hours to allow the cor-
rect temperature to be reached be-
fore placing food inside.
ENGLISH
are recyclable.
5
21