Empire Comfort Systems DVL36BP30 Series Installation Instructions Manual page 16

INSTALLATION
1. Remove the Barrier Screen, Glass Frame, Valve Access
Cover, and Burner Surround. See Maintenance and Service
Section, pages 62, 63 and 64.
Remove cover plates from firebox floor. See Figure 3.
2.
3. Place two self-adhesive Wire Clips approximately where
shown. See Figure 3.
4. Install the two Accent Light Assemblies as shown in Figures
4 and 5. The left assembly's wires should be left, and the
right assembly's wires should point right.
NOTE: Figure 6 shows the general arrangement of wire
routing in the bottom of the fireplace.
5. Plug the power cord into the Junction Box, and route it
through the Wire Clips installed in step 3. See Figure 6.
6. Connect the Wire Assembly to the power cord and Rheostat
Leads, as well as to the Accent Light Assembly Leads. See
Figure 6. An additional Wire Clip can be placed on the left.
7. Attach the Rheostat Bracket to the front-right corner of the
fireplace bottom surround as shown in Figure 6.
Page 16
LIGHT KIT INSTALLATION (CONT'D)
TOP SECTION VIEW
Figure 3
Figure 5
10"
18"
GASKET
Figure 4
41978-1-1220