EA Technology CableData CDC2 Operating Manual page 43

EA Technology CableData Collector Operating Manual 1365/L/01/1
If a valid phase reference is found at the start of the data capture, but is lost part way
through, then this will be shown in the Capture Report at the end of the capture. In Figure
55, the last line of the Capture Report states Number of Phase Reference Lost Errors:
1530. This number may vary but generally for a good phase reference should be zero. If this
number is anything other than zero then the phase reference transformer should be
considered as an alternative source for the phase reference.
Figure 55 - Status report for data with missing phase reference
The capture reports can be saved by clicking the Save To File button. This will bring up the
Save As dialogue box, which can be seen in Figure 56. The destination for the capture
report to be saved to should be selected, and the Save button pressed to save the file.
Figure 56 - Save As window for capture report
After the file has been saved, a message will be displayed to confirm the successful writing
of the file, as can be seen in Figure 57.
Page 39 of 54