Table of Contents
Advertisement
1
2
3
4
26
DOOR PANEL PREP
STAINLESS STEEL PANEL
Determine the panel orientation based
on the hinge and handle position.
Remove the four handle plugs from the
door panel. Align and secure handle
using M5x25 screws from handle kit.
Repeat for lower door.
Remove both top covers using a
powered driver. Set aside.
Remove both washers and nuts and set
aside. Lift the panel brackets outwards
to remove.
Align the centre bracket to pre-drilled
holes on the panel.
5
6
7
Remove all blue tape from the panel.
Align the side brackets to the pre-drilled
holes on the panel.
Using the screws supplied in the panel
kit, secure the door panel bracket using
seven screws.
Secure the side brackets using two
screws per bracket from the supplied
panel kit. Ensure side brackets are
fitted tightly and the fasteners are
secured straight.
Advertisement
Table of Contents
