Table of Contents
Advertisement
1
2
3
4
HINGE SWAP (OPTIONAL)
Open the door and remove the door
shelves. Unclip hinge covers from
middle hinges. Loosen the hinge
screws using the supplied Torx T25
driver. Slide the door out and place
onto a protected surface.
Install kit D
Carefully remove hinges from door and
set aside.
Remove both top covers and set aside.
Install kit D
Push on the edge of the outside plates,
lift out and swap to the other side.
Use a flathead screwdriver to remove
the inside plates. Move to the other
side ensuring the rounded corners face
the inside.
5
6
7
8
Check plates are positioned correctly.
Swap hinges as illustrated. Ensure
base of hinge is parallel and
tightened securely.
Refit top covers.
Remove all 4 screws shown. Pull the
trim out from hinge edge and flip 180°.
Ensure the 2x centre clips are on
its marks and the side hooking clip
on place.
Locate trim by hooking clip then
applying pressure to each centre clip
position until clipping sound is heard.
19
Advertisement
Table of Contents
