Inter-m RMX-1426 Operation Manual page 8

RMX-1426
5. Aux Send Controls
These knobs control the Aux Send level for the associated input channel. Rotating
the knob clockwise increases the amount of signal sent to the AUX buss. The Aux
Send is pre-fader, and is not affected by the channel's fader position.
6. EFX Send Controls
These knobs control the EFX Send level for the associated input channel. Rotating
the knob clockwise increases the amount of signal sent to the EFX buss. The EFX
Send is post-fader, and is directly affected by the channel's fader position.
7. Balance Controls
These knobs control the L/R balance position for the associated stereo input
channel. Depending on which output sources are selected with the channel's
Assign Switches (9), the Balance Controls will pan the signal between Left and
Right on the stereo buss, and/or between PGM 1/3 and 2/4 on the Program
busses.
If the knob is rotated to the center, the channel's signal will be sent equally to the
stereo Left and Right, PGM 1/2 and PGM 3/4 busses.
If the knob is rotated fully counter-clockwise (to the left), the channel's signal will
be sent only to the stereo Left, PGM 1 and PGM 3 busses.
If the knob is rotated fully clockwise (to the right), the channel's signal will be sent
only to the stereo Right, PGM 2 and PGM 4 busses.
8. Pan Controls
These knobs control the L/R balance position for the associated mono input
channel. Depending on which output sources are selected with the channel's
Assign Switches (9), the Balance Controls will pan the signal between Left and
Right on the stereo buss, and/or between PGM 1/3 and 2/4 on the Program
busses.
If the knob is rotated to the center, the channel's signal will be sent equally to the
stereo Left and Right, PGM 1/2 and PGM 3/4 busses.
If the knob is rotated fully counter-clockwise (to the left), the channel's signal will
be sent only to the stereo Left, PGM 1 and PGM 3 busses.
If the knob is rotated fully clockwise (to the right), the channel's signal will be sent
only to the stereo Right, PGM 2 and PGM 4 busses.
9. Channel Output Assign Switches
These buttons assign the channel's input signal to the stereo output buss, or to the
PGM 1/2 or PGM 3/4 busses. Any combination of output busses may be chosen.
10. PFL Switches
These buttons are used to monitor each channel's output status via the
headphone jack.
8
Multichannel Audio Mixer