Table of Contents
Advertisement
4 Software installation
Step 01: Power on the system.
Step 02: Insert Utility CD into CD-ROM
Step 03: Open your Internet browser and key in the address http://192.168.0.1. You will
see the below picture. (Notice: Set the IP of client system as the same
domain)
Step 04: Press button "Browser" and search "PKG" file in the CD. (Default path is
"x:\Firmware") then push the "Setup" button.
Step 05: Before you push the "OK Button" for next step.
Step 06:
Please do not power off either your computer or the NAS during this
process.
capacity.
Step 07: When the system upgrade process is completed, you will see the message
below in your web browser.
This could take a few minutes depending on your hard drive
Advertisement
Table of Contents
