Table of Contents
Advertisement
No.
Lens Mount (C mount)
①
Flange Back Adjuster
②
Flange Back Securing Screw Tighten the screw to secure after adjusting the flange back
③
Auto Iris Connector
④
Tripod Socket
⑤
Securing Hole
⑥
⑦ to ⑪
Setup Button
RS485 / Day/Night Switching
⑫
Terminal Block
RS-485 Terminal Switch
⑬
DC 12 V Connection Terminal
⑭
Block
Power Indicator
⑮
3G-SDI Output Terminal
⑯
(Composite) Video Output
⑰
Terminal
RESET Button
⑱
Name
Mount for installing the lens. Any type of C mount lens can
be used. When installing the lens, take care to prevent dust
or dirt from getting inside.
For adjusting the flange back (distance from the lens
mounting surface to image formation surface).
of the camera.
Connector for connecting an auto iris lens.
Supports only DC auto iris.
Socket for securing onto a tripod etc.
Use 1/4"-20 UNC screws with length of 5.5 mm or less.
Can be used to prevent rotation.
Refer to the operation items.
Use when connecting via RS-485 or
remotely controlling the switching
between Day and Night.
During RS-485 communication, set to "ON" for one-to-one
control and "OFF" for daisy-chain connection.
(Last connection device is ON)
Input DC 12 V.
(Take note of the the polarity)
Lights up in green when the camera is turned on.
Image output terminal for 3G-SDI.
Analog image output terminal for SD VIDEO.
Pressing this button sets the camera to the state when it was
powered on.
Function
1 2 - + GND
- +
9
Advertisement
Table of Contents
