Download Print this page

Insignia IS-PA040721 User Manual

Insignia is-pa040721 audio-radio: product information

Advertisement

Quick Links

SAFETY PRECAUTION
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
.
QUALIFIED SERVICE PERSONNEL
DANGEROUS VOLTAGE
The lightning flash with arrowhead symbol, within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage
within the product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
ATTENTION
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
:
WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
SURGE PROTECTONS:
It is recommended to use a surge protector for AC connection. Lightning and power surges
ARE NOT covered under warranty for this product.
INFORMATION TO USER:
Modifications not authorized by the manufacturer may void users authority to operate this
device.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of te FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance wich the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Place the unit on a stable surface.
Avoid installing the unit in locations described below:
Places exposed to direct sunlight or close to heat radiation appliances such as
electric heaters.
On top of other stereo equipment that radiates too much heat.
Places lacking ventilation or dusty places.
Places subject to constant vibration.
Humid or moist places.
EN - 1
SAFETY PRECAUTIONS (CONTINUED)
Dear Customer:
Selecting fine audio equipment such as the unit you've just purchased is only the
start of your musical enjoyment. Now it's time to consider how you can maximize
the fun and excitement your equipment offers. This manufacturer and the Electronic
Industries Association's Consumer Electronics Group want you to get the most out
of your equipment by playing it at a safe level. One that lets the sound come
through loud and clear without annoying blaring or distortion - and most importantly,
without affecting your sensitive hearing.
Sound can be deceiving. Over time your hearing "comfort level" adapts to higher
volumes of sound. So what sounds "normal" can actually be loud and harmful to
your hearing. Guard against this by setting your equipment at a safe level BEFORE
your hearing adapts.
To establish a safe level:
• Start your volume control at a low setting.
• Slowly increase the sound until you can hear it comfortably and clearly, and
without distortion
Once you have established a comfortaable sound level:
• Set the dial and leave it there.
We Want You Listening For A Lifetime
Used wisely, your new sound equipment will provide a lifetime of fun and enjoyment.
Since hearing damage from loud noise is often undetectable until it is too late, this
manufacturer and the Electronic Industries Association's Consumer Electronics
Group recommend you avoid prolonged exposure to excessive noise. This list of
sound levels is included for your protection.
Decibel
Level
Example
30
Quiet Library, soft whispers.(needs period)
40
Living room,refrigerator, bedroom away from traffic. (needs period)
50
Light traffic, normal conversation, quiet office.
60
Air conditioner at 20 feet, sewing machine.
70
Vacuum cleaner, hair dryer, noisy restaurant.
80
Average city traffic, garbage disposals, alarm
clock at two feet.
THE FOLLOWING NOISES CAN BE DANGEROUS UNDER CONSTANT
EXPOSURE.
90
Subway, motorcycle, truck traffic, lawn mower.
100
Garbage truck, chain saw, pneumatic drill.
120
Rock band concert in front of speakers, thunderclap.
(needs period)
140
Gunshot blast, jet engine.
180
Rocket launching pad.
Information courtesy of the Deafness Research Foundation.
INDUSTRY CANADA NOTICE
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
E N- 2

Advertisement

loading

Summary of Contents for Insignia IS-PA040721

  • Page 1 SAFETY PRECAUTION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL DANGEROUS VOLTAGE The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
  • Page 2: Power Supply

    CONTROLS LOCATION 10 5 1. POWER ON/OFF BUTTON 11. FM STEREO/TIME SET BUTTON 2. BAND (AM/FM) BUTTON 12. BATTERY COMPARTMENT 3. TUNE/ (HOUR)/ 13. FM STEREO INDICATOR TUNE / (MINUTE) BUTTONS 4. VOLUME CONTROL BUTTONS 14. HOLD INDICATOR 5. STATION PRESET BUTTON 15.
  • Page 3: Specifications

    MEMORY BACKUP OF STORED STATIONS Once the batteries are low, the LCD display will start flashing or shut off eventually. Press the Power ON/OFF Button to switch off the radio, then replace with new batteries. HOLD With the “HOLD” switch (10) set to the “ON” position, all the buttons will be inhibited. The “HOLD”...