Advertisement
CONTROLS LOCATION
2
11
3
6
1
10 5
12
9
1. POWER ON/OFF BUTTON
2. BAND (AM/FM) BUTTON
+
3. TUNE/
(HOUR)/
TUNE /
(MINUTE) BUTTONS
4. VOLUME CONTROL BUTTONS
5. STATION PRESET BUTTON
6. MEMORY BUTTON
7. PHONE JACK
8. LCD DISPLAY
9. BELT CLIP
10. HOLD SWITCH
POWER SUPPLY
Slide the Battery Compartment cover (12) at the back of the unit and insert two
"AAA"(RO3/UM4) dry cells. Take care that the cells are oriented for correct polarity.
CAUTION
Do not mix old and new batteries.
Do not mix alkaline, standard (Carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
If the LCD starts flashing or shuts off during operation, the batteries should be
replaced.
4
7
16
17
18
15
13
14
19
20
8
11. FM STEREO/TIME SET BUTTON
12. BATTERY COMPARTMENT
13. FM STEREO INDICATOR
14. HOLD INDICATOR
15. PRESET INDICATOR
16. VOLUME LEVEL INDICATOR
17. RADIO FREQUENCY DISPLAY
18. AM/FM INDICATOR
19. TIME AM/PM INDICATOR
20. LOW BATTERY INDICATOR
EN - 3
OPERATION
1.
Press the Power ON/OFF button (1) to switch on the radio.
2.
Select the FM or AM band by pressing the Band Button (2). The FM and AM
bands are alternately selected each time when the Band Button is pressed.
3.
Insert the headphone plug into the Phone Jack (7) if "
+
4.
Press the "TUNE /
" (HOUR) or "TUNE /
Higher frequency can be selected by pressing the "TUNE /
lower frequency by "TUNE /
Press either button for more than 1 second to activate the automatic
tuning mode and it will stop automatically when a station is reached.
+
Press "TUNE /
" or "TUNE /
necessary.
+
Press the "TUNE /
" or "TUNE /
The automatic tuning will continue to scan even when the search has
reached either of the band edges (max. frequency or min. frequency).
Once the search reaches max. (or min.) frequency, it will return to min. (or
max.) frequency and continue to search upwards (or downwards).
5.
Adjust the volume by pressing the Volume Control Button (4) "
desired level.
6.
Select Mono or Stereo mode by setting the "FM STEREO" switch (11) to your
desired choice, when listening with headphone to the FM band.
PRESET TUNING
Once the desired stations are stored in the memory, they can be recalled easily. Up
to 10 AM and 10 FM stations can be stored in the memory.
Perform the following in sequence to store a station frequency into the preset
channel.
1.
Tune in a desired station frequency according to the normal tuning procedure.
2.
Then press the "MEMORY" (6) button. PRESET Indicator (15) will appear on
the Display (8) and blinks.
3.
Select the desired preset channel by pressing the "PRESET" button (5).
4.
Then store the desired frequency into the channel by pressing the "MEMORY"
button again.
5.
Repeat steps 1 – 4 to store other frequencies in channels 1 –10.
MEMORY RECALL
Recall the stored frequencies 1 – 10 by pressing the "PRESET" button (5).
EN -4
" position is selected.
" (MINUTE) Button (3)
+
" button and
" button.
" button to adjust for the best reception if
"button again to select another station.
+
" or " " to the
Advertisement
