Advertisement
BASIC WEIGHING
NOTE 1: All reference to weighing position refers to raising the forks
or bucket up to a pre- determined position and lowering
slightly and slowly.
The pre-determined position is determined by the installer
and is generally indicated by stickers on the mast for a
forklift (Raise to 1, Lower to 2) and on the carriage (Arrow)
or other markings on a loader.
1.
With the forks empty and mast upright, raise forks up to the
weighing position.
(If other than 0.00 (zero) is displayed press ZERO key and hold
for 3 seconds)
2.
Apply the load and raise up to the weighing position. The weight
will vary as the load is raised and then lowered but should
stabilise after 2-3 seconds.
3.
To Accumulate the weight once the weight has been obtained,
Push the "ADD" Key once. The Bucket Count and the
11
Advertisement
