Technical Specifications; Using The Battery Pack - Insignia I-PD720 User Manual

Technical specifications

Laser wavelength
Video system
Frequency response
Signal/noise ratio
Audio distortion + noise
Channel separation
Dynamic range
Audio out (analog audio)
10kohms
Audio out (digital audio)
Video load impedance
Power supply
Allowable motion temperature
Power Consumption
This manual is only for your reference. Any change to the design and specifications
will not be advised.
This product incorporates copyright protection technology that is protected by method
claims of certain U.S. patents and other intellectual property rights owned by Best
Buy Corporation and other rights owners. Use of this copyright protection technology
must be authorized by Best Buy Corporation, and is intended for home and other
limited viewing uses only unless otherwise authorized by Best Buy Corporation.
Reverse engineering or disassembly is prohibited.

Using the battery pack

Attach the battery pack properly by following these directions. Make sure that the
battery pack is attached firmly to the player when using it. Otherwise, the battery may
become detached and cause person injury. Charge battery pack before using it.
Attaching the battery pack
First disconnect the AC adapter and the power cord from the player, and then attach
the battery pack.
1. Turn the player off.
2. Turn the player upside down.
3. Insert the battery pack's catches into the player's corresponding holes. Then,
slide the battery pack until it is attached firmly.
Note: Remove the battery pack from the player after being used.
Charging the battery pack
1. Turn the player off. The battery pack will charge only when the POWER to
the player is turned OFF.
2. Attach the battery pack to the player.
3. Connect the supplied AC adapter and the power cord to the player. Charging
starts, and the POWER/CHG indicator light is illuminated. When the charging
is complete the indicator light turns off.
650nm
NTSC
20Hz 20KHz ±1dB
≥95dB
≤-80(1KHz)
≥85dB
≥85dB
Output
Output level: 2V±10% Load impedance:
Output level: 0.5Vp - p
Video out Output level: 1Vp - p±20%
75 Ohm, imbalance, negative polarity
DC 9V 2A
5 – 35degrees Celsius
≤20W Dimensions 190×142×29mm
Weight 825 g (1.8 lb)
- 34 -