Table of Contents
Advertisement
3.
If switch does not support PoE, use external power supply included in the
package
4.
Assign unique
the Front Panel using UP and DOWN arrow keys or by using IR Remote
Controller (See
5.
Connect HDMI Source(s) to Sender(s)
6.
Connect HDMI Display(s) to Loop out as required
7.
Connect HDMI Display(s) to Receiver(s)
8.
Connect
9.
If extending bidirectional IR, connect IR Emitter cable to "IR-OUT" port and IR
detector cable to "IR-IN" port of both Sender and Receiver. See
more details.
10. If Using RS-232, connect RS-232 cable from PC or automation system to the
supplied phoenix connector, and then connect it to the "RS-232" port of
VERSA-4K. See
11. To control the unit from WEB-GUI or PC-GUI change the IP address of the PC
to
Auto IP
12. Assign
Device Name
8
Group ID
to each Sender. The Group ID can be changed from
Front Panel operation
IR Detector
cable to "IR-CTRL" port to use IR Remote Controller
Serial over IP
network
to Sender(s) and Receiver(s) from WEB-GUI or PC-GUI
for more details)
for more details.
IR Over IP
for
Advertisement
Table of Contents
