Error Displays - Clarion Automobile Accessories User Manual

7. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display
ERROR 2
ERROR 3
ERROR 6
NO IPOD
ERROR 2
ERROR 3
ERROR 6
AMP GRD
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Cause
A DISC is caught inside
the CD deck and is not
ejected.
A DISC cannot be played
due to scratches, etc.
A DISC is loaded upside-
down inside the CD deck
and does not play.
A communication error
occurs between the iPod
and the iPod CeNET
Interface.
A CD inside the CD
changer is not loaded.
A CD inside the CD
changer cannot be played
due to scratches, etc.
A CD inside the CD
changer cannot be played
because it is loaded
upside-down.
The speaker protection
circuit is operating.
During this operation, if
any volume operation is
performed, the display
shows "AMP GRD".
"AMP GRD" sometimes
functions when special
test signals are used.
Measure
This is a failure of CD deck's mechanism and
consult your store of purchase.
Replace with a non-scratched, non-warped-disc.
Eject the disc then reload it properly.
Disconnect the iPod, then connect it again.
This is a failure of CD changer's mechanism.
Consult your store of purchase.
Replace with a non-scratched, non-warped disc.
Eject the disc, then reload it properly.
1. Turn down sound volume. Function can also
be restored by turning the power off and on
again.
(Speaker volume is reduced automatically
when the speaker protection circuit operates.)
2. If the sound is muted again, consult our
service department.
37
M475