Baltech ACCESS200 Installation Manual

ACCESS200 installation guide for SNET

1. Install readers

Fix the base part to a single gang box or directly to the mounting surface.
Use 3 mm diameter countersunk head screws. Heads must not stand out
more than 1 mm from the base surface.
When using stranded wires, make sure there are no wires outside the
•
cages of the pluggable cage clamp.
To avoid rain interference, mount outdoor keypad readers upright or
•
at a protected spot. Otherwise, ensure large water drops are wiped off
if readers are malfunctioning.
Pigtail cable connection / Molex Pico-SPOX (outdoor/potted
versions) stranded, AWG28, power Red&Black AWG 24
Color Connector pin #
White/Orange
Orange
White/Green
Green
Red/White
Black/White
Red
Black
White/Blue
Blue
White/Brown
Brown

2. Optional: Set bus address

This step is only needed if you want to assign each reader an individual address: Present a
BALTECH AdrCard to the reader, and wait for the signal indicating the desired address.
Learn more:
docs.baltech.de/bus-address
Note: The documentation refers to the OSDP protocol, but the steps for SNET
are the same as both protocols are based on RS-485.
BALTECH AG Phone:
Lilienthalstrasse 27 Fax:
85399 Hallbergmoos Mail:
Germany Website:
Signal/funct.
1 WIE_D0/RS485A
2 WIE_D1/RS485B
3 LEDGN
4 LEDRD
5 USB Data -
6 USB Data +
7 +VIN
8 GND
9 GND
10 REL_WC
11 REL_NO
12 REL_NC
+49 (811) 99 88 1-0
+49 (811) 99 88 1-11
info@baltech.de
www.baltech.de
Connector and pins
(reader rear view)
J8 Pluggable cage clamp
(indoor versions)
Pin # Signal/funct.
J8-1 GND
J8-2 +Vin
J8-3 WIE_D0/RS485A
J8-4 WIE_D1/RS485B
J8-5 LEDGN
J8-6 LEDRD
J8-7 REL_WC
J8-8 REL_NO
J8-9 REL_NC
v1.1
p 1/2