Baltech ACCESS200 Installation Manual

ACCESS200 installation guide
Here's a quick overview of the steps to install an ACCESS200 reader. More detailed
instructions are available online – just follow the links or QR codes below.

1. Install readers

Mounting guidelines:
•
Fix the base part to a single gang box or directly to the mounting surface.
Use 3 mm diameter countersunk head screws. Heads must not stand out more than
1 mm from the base surface.
•
When using stranded wires, make sure there are no wires outside the cages of the
pluggable cage clamp.
•
To avoid rain interference, make sure outdoor keypad readers are mounted upright or
at a protected spot. Otherwise, ensure they're wiped off if malfunctioning.
Connector and pins:
Pigtail cable connection / Molex Pico-SPOX (outdoor/potted
versions) stranded, AWG28, power Red&Black AWG 24
Color Connector pin #
White/Orange
Orange
White/Green
Green
Red/White
Black/White
Red
Black
White/Blue
BALTECH AG Phone:
Lilienthalstrass<e 27 Fax:
85399 Hallbergmoos Mail:
Germany Website:
Signal/funct.
1 WIE_D0/RS485A
2 WIE_D1/RS485B
3
4
5 USB Data -
6 USB Data +
7
8
9
+49 (811) 99 88 1-0
+49 (811) 99 88 1-11
info@baltech.de
www.baltech.de
J8 Pluggable cage clamp
(indoor versions)
Pin #
J8-1
J8-2
LEDGN J8-3
LEDRD J8-4
J8-5
J8-6
+VIN J8-7
GND J8-8
GND
Signal/funct.
GND
+Vin
WIE_D0/RS485A
WIE_D1/RS485B
LEDGN
LEDRD
REL_WC
REL_NO
v1.0