Turning Off The Projector - InFocus LS700 User Manual

S e t t i n g
CAUTION: When you
disconnect the projector after you
have switched it off, always
remove the power cord from the
electrical outlet first, then remove
it from the projector.
12
u p t h e

Turning Off the Projector

If you want to turn off the projector for a short period of time,
press the
standby
screen for 1 minute, but keeps the projector running. After 1
minute, the lamp goes out (the projector keeps running). To exit
standby mode, press the
seconds for the projection lamp to reach full power and project
the image again.) You can change the amount of time the projec-
tor stays in standby mode; see "Standby Time" on page 27 for
details.
To completely power off the projector, press the "O" side of the
power switch on the front of the projector. If you want to turn the
projector back on immediately, you must allow about 30 seconds
for the lamp to cool. The lamp won't light if it's too hot.
P r o j e c t
button on the remote or keypad. This blanks the
button again. (It takes several
standby
o r