Operating Your Qtac; Before Starting Up Your Qtac; Pump Operation; Tank Fill Requirements - QTAC 20S Owner's Manual

OPERATING YOUR QTAC

Before Starting Up Your QTAC

•
Always wear appropriate eye, ear, and body protection when operating your
QTAC unit.
•
Ensure that your QTAC has sufficient water in the water tank prior to operation.
The water level can be checked by viewing the water tank site gauge located on
the side of the water tank (Figure 1, Item 5) If the water tank is low on water,
open the water tank fill lid (Figure 1, Item 2) and fill the water tank with water.
•
Check the pump engine fuel (Figure 3, Item 3) and oil levels (Figure 3, Item 7) as
needed, fill the pump engine with fuel and oil as specified in the engine manual
that came with your QTAC. For more information, see the Pump Operation
Manual and the Honda Owner's Manual.
•
Prime the pump as needed by removing the plug at the pump prime port and
filling the pump head with clean water (Figure 2, Item 1) If the pump has been run
recently with plain water, this step will likely not be needed as the pump will retain
its prime for some time. For more information, see the Pump Operation Manual.

PUMP OPERATION

Tank Fill Requirements:

MAX FILL PRESSURE: 100 PSI
MAX FILL RATE: 150 GPM

Tank Fill Through the Fill Tower

1. Open the water fill lid and fill the tank. (Figure 1, Item 2)
Page | 8