Servicing Your Qtac; Cleaning Your Qtac; Protecting Your Qtac; Routine Qtac Maintenance - QTAC 20S Owner's Manual

Remove the cap from the pump primer port and fill the pump as needed (Figure
2, Item 3) with clean water. Ensure that all the foam has been forced from the
pump by continually pouring water into the primer port until all foam has been
displaced.

SERVICING YOUR QTAC

Cleaning Your QTAC

Your QTAC water tank is best cleaned with plain water. If additional cleaning power is
needed, a small amount of dish or car washing soap may be used. Avoid heavy
washing of the pump engine and surrounding area. Avoid the use of high pressure
spray on the water tank as the decals and rubber components may be damaged.

Protecting Your QTAC

Your QTAC is built of welded UV-stabilized copolymer polypropylene red plastic.
However, like any colored material, extended exposure to direct sunlight can eventually
fade the finish of the tank, hoses, hose reel and even the Honda engine. To keep this
from happening, cover the QTAC if it is stored outside and in direct sunlight. Also,
consider using a UV inhibitor on the plastic and rubber parts after washing the system,
such as 303 Aerospace UV Protectant.

Routine QTAC Maintenance

With the exception of the pump and pump engine, your QTAC requires no special
maintenance. For maintenance of the pump and pump engine, see the appropriate
manuals.

TROUBLESHOOTING YOUR QTAC

The Pump Engine Will Not Start

• Ensure that the engine switch is in the "ON" position.
Page | 12