Table of Contents
Advertisement
OPERATING YOUR QTAC
Before Starting Up Your QTAC
•
Always wear appropriate eye, ear, and body protection when operating your
QTAC unit.
•
Ensure that your QTAC has sufficient water in the water tank prior to operation.
The water level can be checked by viewing the water tank site gauge located on
the side of the water tank (Figure 1, Item 5) If the water tank is low on water,
open the water tank fill tower (Figure 1, Item 3)and fill the water tank with water.
•
Check the pump engine fuel (Figure 3, Item 1) and oil levels (Figure 3, Item 5) as
needed, fill the pump engine with fuel and oil as specified in the engine manual
that came with your QTAC. For more information, see the Pump Operation
Manual and the Honda Owner's Manual.
PUMP OPERATION
Priming the Pump
The ACE Pump is not a self-priming pump. To prime the pump, open the primer valve
(Figure 2, Item 6), and operate the Guzzler hand primer (Figure 2, Item 9) until water
flows back into the tank.
Tank Fill Requirements:
MAX FILL PRESSURE: 100 PSI
MAX FILL RATE: 150 GPM
Page | 9
Advertisement
Table of Contents
