Switch Operation - XGuard IntelliSwitch User Manual

XGuard

SWITCH OPERATION

A) WHEN BATTERY IS FIRST CONNECTED TO THE SWITCH
Wait until the switch is armed and ready
which is indicated by alternating blinking
GREEN and RED LEDs.
Once it's armed you can click once and
the switch will turn on and send power to the output ports. The se-
lected battery mode of operation is indicated by a series of beeps
from 1 to 6 depending on what is programmed as the mode of op-
eration. If not clicked ON withing 3 seconds it will go to standby.
B) WHEN SWITCH IS ON STANDBY
If you turned the switch off via holding the the ON/OFF button for
more than three seconds the switch turned OFF by entering into
standby mode. When in standby mode you need to click once to
arm the switch which is indicated by alternating blinking GREEN
and RED LEDs.
Once it's armed you can click once and the switch will turn on and
send power to the output ports. The selected battery mode of op-
eration is indicated by a series of beeps from 1 to 6 depending on
what is programmed as the mode of operation. If not clicked ON
withing 3 seconds it will go to standby.
IntelliSwitch
Page: 9 Copyright 2020 XGuard RC. All rights reserved