Table of Contents
Advertisement
XGuard
MOUNTING THE SWITCH
A) Double-Sided Tape
Use two pads of dou-
ble-sided tape 1mm
or thicker on the buzz-
er side to attach to a
clean surface of your
aircraft
B) Panel Mount
Make sure that your panel
mounting hole dimensions
are at least the size of the
ones in this diagram.
Mount the switch using the
supplied screws and carbon
fiber cover plate.
WARNING: Do not over-
tighten the screws or you
will break the plastic thread.
IntelliSwitch
Page: 7
Copyright 2020 XGuard RC. All rights reserved
Add two pieces
of thin double-
sided tape
13mm x 6.25mm
(not included)
Advertisement
Table of Contents
