Locator Alarm Switched On By Radio Switch - XGuard IntelliSwitch User Manual

XGuard

LOCATOR ALARM SWITCHED ON BY RADIO SWITCH

Program an unused channel like AUX1 to be controlled by a
switch. Use this channel to turn on or of the locator buzzer by
plugging it to the top port as shown below.
Connect the servo wires to
two receiver/FBL ports
ON
OFF
Note: If the positions are reversed go to the radio's
setting screen and reverse the switch channel.
IntelliSwitch
If you want to control the
locator buzzer plug a switched
channel into the switch's top port
ON
Three
Position
Switch
OFF
Page: 8
Turn locator buzzer
Two
Position
on by using the
Switch
radio switch
Copyright 2020 XGuard RC. All rights reserved