ALDI FERREX 705715 User Manual page 17

65 W Multifunctional sharpener
4) To alter the angle:
• Loosen the angle adjusting knob in an
anticlockwise direction.
• Adjust the plate. The sharpening angle is
indicated by the small arrow. The adjustable
grinding angle is from 15°to 50°. Make sure the
blade edge touches the grinding wheel.
• Tighten the angle adjusting knob (See Fig. E2).
5) Insert the plug into the mains power socket
and switch on the power. Move the on/off switch
(10) to the "I" position to turn the sharpener on.
6) Slide the blade and plate with light steady
pressure back and forth across the grinding
wheel (1) in a continuous motion. Do not hold
the blade stationary. This causes irregular
sharpening (See Fig. E3).
7) Gradually adjust the blade down the plate
while sharpening. Do not press hard. Grind
gradually, repeating the step (See Fig. E4).
8) Remove the blade and make sure the beveled
edge and tip are evenly sharp. If not, adjust
the grinding angle. It is important that the
sharpening angle matches the existing beveled
angle of the blade. This avoids removing too
much metal unnecessarily and keeps planer
blades at their optimum shaving angle (See Fig.
E5).
9) When sharpening thin chisel blades, place
the small chisel guide onto the plate to act as a
spacer and sharpen as before (See Fig. E6).
E5.
AFTER SALES SUPPORT
1300 889 028
(toll free)
E6.
MODEL No.:
E2.
E3.
E4.
e-mail: info.aldi@positecgroup.com
BDS651 • 05/2021 • 705715
14